ISO INTERNATIONAL STANDARD 14396 First edition 2002-06-01 Reciprocating internal combustion engines Determination and method for the measurement of engine power - Additional requirements for exhaust emission tests in accordance with lsO 8178 Moteurs alternatifs a combustion interne Détermination et methode de d'émissions de gaz d'échappement suivant IisO 8178 Reference number A ISO 14396:2002(E) ISO @ ISO 2002 THS under I without license from IHS Not for Resale ISO 14396:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ISO2002-All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 14396:2002(E) Contents Page Foreword i Introduction Scope 2 Normative references. : Terms and definitions 4 Symbols.... 5 Standard reference conditions 6 Tests.... 6.1 Test method 6.2 Test conditions 6.3 Test procedure. 7 Method of power correction . 8 Measurement of exhaust emission, 9 Test report ... 9.1 General.. 9.2 Statement of results as a function of engine speed 10 Tolerance for measuring engine power... Bibliography.. ii by IHS under lic se from IHS Not for Resale