ISO INTERNATIONAL STANDARD 12151-1 Second edition 2010-06-15 Connections for hydraulic fluid power and general use Hose fittings Part 1: Hose fittings with ISO 8434-3 O-ring face seal ends Raccordements pour transmissions hydrauliques et applications generales - Raccords de flexible - Partie 1: Raccords de flexible avec embouts a joints faciaux toriques conformes a /lSO 8434-3 Reference number ISO 12151-1:2010(E) @ ISO 2010 HS under I without license from IHS Not for Resale ISO 12151-1:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @SO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means isO's memberbody in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ Iso 2010 - All rights reserved ed without license from IHS Not for Resale ISO 12151-1:2010(E) Contents Page Foreword i Introduction 1 Scope 2 Normative references. 3 Terms and definitions 4 Performance requirements. 5 Designation of hose fittings 6 Design. 7 Manufacture 8 Assembly instructions.. 9 Procurement information.. 10 Marking..... 11 Identification statement (reference to this part of ISO 12151) . Annex A (informative) Illustrations of applications for short, medium and long Iso 12151-1 hose fittings.... .14 Bibliography... ..15 Copyright internatinal organizaio for Standardizalion ghts reserved ii se from IHS Not for Resale